Clearblue Digital Ovulation Test Double Hormone Indicator 10 sticks

Clearblue Ovulation Test

Medical Device CE 0843.
The ovulation test detects the increase (peak) of luteinizing hormone (LH) in the urine. This peak occurs approximately 24 to 36 hours before the ovaries release an egg, a process known as ovulation. Fertility is highest on the day the LH surge is detected and the day after. The 2 most fertile days begin when the Clearblue DIGITAL Ovulation Test detects the LH surge. Sex in the next 48 hours will give you the highest chance of getting pregnant.

How to use
- Remove the stick from the protective wrapper. Use the stick immediately.
- Before applying urine to the test stick, it must be inserted into the test holder. Proceed as follows.
- Locate the pink arrow on the stick.
- Locate the pink arrow on the test holder.
- Line up the two pink arrows.
- Insert the stick into the holder until it clicks into place and the Test Ready symbol appears.
- Do not use the stick until the Test Ready symbol appears.
- When the Test Ready symbol appears, test immediately.
- If the Test Ready symbol does not appear OR has disappeared, remove the stick and reinsert it carefully.
- If the symbol does not appear in this case either, please refer to question 19 on the back.
- When the Test Ready symbol appears on the display.
- The test can be performed directly under the urine stream.
- Keep the absorbent tip pointing downwards under the urine stream for 5-7 seconds.
- Be careful not to get the test holder wet.
- Or test using a urine sample collected in a clean, dry cup.
- Immerse only the absorbent tip in the urine sample cup for 15 seconds.
- Leave the absorbent tip pointing down or lay the test horizontally. For the duration of the test, never hold the test stick with the absorbent tip pointing upwards.
- The Test Ready symbol will start flashing after 20-40 seconds to confirm that the test is working correctly.
- DO NOT REMOVE THE STICK.
- Put the cap back on and remove excess urine with a cloth or absorbent paper.
- If the Test Ready symbol does not start flashing, please refer to question 6 on the back.
- The result will appear on the display within 3 minutes.
- Once you have read the result, you need to press the eject button and remove the stick.
- The test result can only be read on the test holder display.
- Any visible lines on the stick are not indicative of any results.
- The result will remain visible on the display for 8 minutes.
- If the stick is still inserted, but the result has disappeared from the display, pull out the stick and the result will appear again for 2 minutes.
- Do not reinsert a stick that has already been used.

Warnings
Keep out of reach of children. Do not use if the sealed casing of the stick is damaged. Do not use an expired stick.

storage
Store at room temperature.

Code 81434864